Upright 4 tube clock module
A 4 tube clock module that uses the upright Nixie tubes.
Pre assembled and tested, this module uses 4 of the German Z570M nixie tubes with a 13mm digit height. An easy module to fit as it just requires the cutting of round holes for the tubes. The tubes are mounted a pre-set height above the circuit board, so you can use a spacer or washers to get the tubes the exact height to fit into your own casing. There is a single connection point on the board where you connect the power and wire up the push buttons.
- 4 off Z570M German Nixie Tubes
- Board footprint 110mm X 55mm
- Just need two push buttons and a power connector
- Supplied assembled and tested
- Complete with mains power supply
- 12 / 24hr mode
- Leading zero suppression
- Sleep mode
- Anti tube poisoning routine
- Supplied with blue LED backlights, please ask if you need a different colour
Mechanical drawing supplied with the module to give all the dimensions needed to mount the board.